Sunday, September 7, 2008

Tech Tip: Fuel Filter Screen

Has your doctor recently informed you that your advancing age and your lack of exercise has resulted in the following symptoms: hard starting, rough idle, poor acceleration, inability to perform when called upon!!!??? If you answered yes, then you have something in common with your Thunderbird. You are both suffering from "sludge build-up!" Your doctor is the expert on you! Your car's problem, however, may best be solved by our own Dr. Ken Smizinski.


Ken has passed on the following information concerning your 1955-57 Thunderbird fuel filtration system. Your car has two "filters" which attempt to remove debris from your fuel before it enters into your carburetor. The first filter is the one in the glass bowl located in front and to the side of your engine. It is located in the fuel line as it makes its way from the fuel pump to the carburetor. The second "filter" is the one that is most often overlooked and forgotten. If you have changed your fuel filter recently, yet your car still suffers from poor acceleration, your problem may be a clogged fuel screen. This screen is your fuel systems second filter. It is located behind the brass fitting which connects your fuel line to the carburetor. With the advance of time, as well as the fact that our cars are not used on a frequent basis, the gas in our gas tanks is prone to sediment build-up. This "sludge" will clog your fuel filters. That is what they are there for, to protect your carburetor.

To clean your fuel screen, you first have to remove the fuel line from the brass fitting. On 1955 and 1956 Thunderbird's your fuel line should go to the back of your carburetor. On 1957 Thunderbird's your fuel line will go to the side of your carburetor. Once your fuel line has been removed, unscrew the brass fitting from the body of the carburetor. There will be a rubber gasket attached to the brass fitting. This gasket must be reinstalled behind the brass fitting or your car will be leaking gas!!!! Inside the brass fitting will be a wire screen. This is your fuel screen. You can tap it out of the brass housing. Inspect the screen for sediment buildup. Your screen can be cleaned with carburetor cleaner. If your screen is bent or missing, you will need to order a replacement screen. Once your screen has been cleaned or replaced, reinstall the fuel screen back inside the brass housing. Reattach the brass housing to your carburetor. Do not forget to reinstall the rubber gasket! Once you have installed the brass housing reconnect your fuel line. If your screen was clogged. you should notice a definite improvement in your car's performance.

Source: CTCC Tech-Tip Manual 1993-1997

1 comment:

Unknown said...

Great blog post. I used to be checking continuously this blog and I am impressed! Extremely helpful information specially the closing phase :) I deal with such info a lot.
Natural Gas Filter